Cousins Packaging - Model HP2100-SRT Semi-Automatic High Profile Turntable

PRODUCTION SPEED:
Up to 35 loads per hour
NOTE: Process rates will vary with load size,
number of wraps & forklift load/unload time

LOAD CAPACITY:
Maximum load weight: 4000# dynamic – 10,000# static
Maximum load size to safely clear the tower: 56” x 56” (79” diagonal) x 75” H

HIGH PROFILE TURNTABLE:
48” Octagonal 5/16” thick, formed steel plate
4 point caster support system
Turntable height less than 11” from floor
ANSI # 50 direct chain drive c/w chain tensioner
3-12 RPM rotational speed c/w soft start acceleration
1/2 HP AC variable speed motor
Final revolution deceleration and positive stop alignment
Front and back forklift ports for easy movement
Accu-Count exact turntable positioning system for additional film savings.

FILM CARRIAGE ELEVATOR:
1/2 HP AC variable speed motor
ANSI #40 direct chain drive c/w shock dampener & Anti-Fall Safety Device

FILM DELIVERY SYSTEM:
Super Rapid Thread II™ 20” capacity pre-stretch film carriage
Special Film Threading Device – Uniquely orients the sticky side of the film against the pre-stretch rollers and the inside of the load.
1/2 HP AC variable speed motor
Fully electronic dynamic dancer corner compensation
33% to 313% fixed stretch capability
Pre-stretch ratio variable using easy sprocket change
Carriage Descent Obstruction Safety Shut-Off Device
Rapid Thread ™ Safety Door with auto power cut-off switch
Side mounted film carriage for operator convenience and safety
Superior film-to-roller contact area
Lifetime warranty on pre-stretch rollers

CONTROL FEATURES:
Electronic controls with LCD operator interface
Power Off – On – Reset switch & Power On indicator light
Single button Auto Wrap Cycle Start/Pause
Cycle Pause for applying top sheets
Reinforce Wrap control for mid-wrapping
Base or Top Wraps First program
Up Only or Up/Down wrap program
Emergency Stop button
Turntable Jog button
Film Carriage Lower & Raise buttons
Film Tension (Force-to-Load) control
Separate film carriage raise & lower speed controls
Operator programmable turntable speed control
Triple beam automatic load height detection sensor for dark or shiny loads
Separate 1 to 12 revolution top & bottom wrap control
Selectable Reduced Film Tension parameters for wrapping top and/or bottom of load
Cycle counter
A – B – C wrap program selector with capability to input and store unique wrapping parameters for each program
PASSWORD PROTECTION - Wrap program setting can be password protected when ordered from the factory (must be specified on the PO)

STRUCTURAL FEATURES:
All structural and formed steel construction
Forklift truck portable base structure design – lifting tubes included for front and rear access
Electro-static powder coated paint finish

ELECTRICAL INPUT REQUIREMENTS:
115 Volts 1 Phase 60 Hz 15 Amps with dedicated service